Toolchain setup

Initial setup

Download the following:

TunerPro RT
WinLog or Winlog 14point7. The latter has no nag screens, and the software is abandonware anyway at this point.
Clone or download as "zip" the repository on GitHub.

After installing, edit the TunerPro shortcut and add the -multiinstance command line parameter, this will allow you to open multiple TunerPro instances at the same time.
Copy the checksum plugin (M232csum.dll) to My Documents\TunerPro Files\Plugins. If you are using Windows 10 it can also be in your OneDrive folder. Best way to see is to start TunerPro once and exit.
Load the .xdf file (XDF -> Select XDF).
Load the acquisition file (Acquisition -> Load Definition File).
Load the binary file (File -> Open Bin).
In the upper left corner of the map selection view, choose to view by "Category".

Load the dashboard. File -> Open Dashboard
Load the M2.3.2 driver. View -> Device Configuration
- If the driver is not listed -> Have disk and select WinlogM232FastDiag.dll
- A window will pop-up with settings - select the COM port you are using for your cable/splitter. The sensor settings are pre-set for the MPXH6400A
Turn on the ignition and if you did everything correctly, you should see data streaming
To log File -> Start new datalog
To view/stop log File -> Open last datalog
When using WinLogView - File -> Open Graph, and select m232_fast.wlg for a pre-configured view.

If you want to use WinLog and the TunerPro acquisition at the same time, then you will need a COM port splitter.
A few links: